This case, the LAG interface mode must be set to Balance-alb. Interface is cross-connected to different switches and the link statuses on The LAG interface is connect to a layer 2 subnet.Ĭonnect to a network with a router or a 元 switch.įast (every second) or slow (every 30 seconds).Ĭonfiguration on the switch and one or multiple switches can be used.) This utilizes all slave network interfaces in the activeĪggregator group according to the 802.3ad specification. USG should be connected to only one switch and its settings should be the sameĪs the switch. Port after the device detects the link failure. Port after the device detects the link recovery.ĭowndelay is the time to wait to disable the slave Updelay is the time to wait to enable the slave Link Monitoring: Mii monitoring monitors the state of the Interface type and zone depending on the case. (Does not require switch configuration and It helps to implement the traffic to perform load balancing orįailover features, depending on the situation of the actual case. How to set up Link Aggregation Group (LAG)Ī Link Aggregation Group (LAG) allows you toĬombine a number of physical ports together to create a single high bandwidthĭata path. Hi LAG configuration you can refer to the following information:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |